Avaya 5900 Series Installing Manual page 64

Switch installation
• For a stack configuration, enter a value in the In-Band Stack IP Address field in dotted-
decimal notation.
3. In the In-Band Subnet Mask field enter the appropriate subnet mask in dotted-decimal
notation.
4. In the Default Gateway field, enter the appropriate default gateway in dotted-decimal
notation.
5. Press CTRL + C to return to the main menu.
Assigning IP parameters using the console menu and ACLI
Procedure
1. Connect a terminal to the console port of the switch.
2. Set the terminal protocol on the terminal or terminal emulation program to VT100 and
VT100/ANSI.
3. Connect to the switch using the terminal or terminal emulation application.
4. After the Avaya banner is displayed, press CTRL + Y to display the main menu.
5. Select Command Line Interface. . . from the main menu.
6. Enter the Global Configuration command mode using the enable and configure
terminal commands.
7. In the Global Configuration command mode, use the ip address command to set the
switch or stack IP address.
8. Initial IP configuration is now complete. To continue with configuration operations, use the
appropriate CLI commands. To disconnect from the switch use the logout command to
return to the Console Menu and select Logout from the main menu.
Job aid
Any terminal or PC with an appropriate terminal emulator can be used as the management station.
The following table lists the parameters that must be used with any terminal emulation software
used to connect to the switch.
Table 18: Terminal emulation settings
Property
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
September 2017
Value
9600 bps
8
1
None
None
Installing Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
64