Installing The Fork Legs; Removing The Lower Triple Clamp - KTM 350 EXC-F 2022 Owner's Manual

12.8

Installing the fork legs

12.9

Removing the lower triple clamp

Main work
–
Position the fork legs.
Bleeder screws
Info
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
be flush with the upper edge of the upper triple clamp.
402556-10
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom triple
clamp
V01756-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
K00546-10
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove front fender. (
–
Remove the handlebar cushion.
SERVICE WORK ON THE CHASSIS 12
1
are positioned toward the front.
2
.
M8 20 Nm (14.8 lbf ft)
3
.
M8 15 Nm (11.1 lbf ft)
M8 25 Nm (18.4 lbf ft)
5
.
( p. 102)
p. 115)
( p. 101)
( p. 62)
p. 68)
4
.
Loctite ® 243™
p. 114)
p. 113)
p. 60)
63