Appendix C: G24-Lc (Charger Model - Motorola G24-L Technical Information

Appendix C: G24-LC (Charger Model)

General Description
The G24-LC may be operated on the Developer Board using an external battery.
Note:
The battery should be connected to the developer board in the same manner as when using an
external power supply. The battery positive (+) and negative (-) supply contacts should be
connected to the Developer Board's VCC and GND contacts, respectively, and the battery's
thermistor contact should connected to the corresponding Developer Board's ADC3 pin (pin 47)
in the 70-pin header connector (P100).
The battery will supply power to the G24-LC module along with the Developer Board's
peripheral circuits.
In case battery charging is required, the external charger should be connected through the
Developer Board's USB connector (J380). The wall mount adapter provided with the Developer
Kit may be used as the battery charger.
Important:
September 25, 2007
The battery is not supplied with the Developer Kit, and must be obtained separately.
The recommended battery and charger accessories, which are defined in the G24-L
Module Hardware Description (6802984C05), should be used.
The electrical and environmental operating limits of the battery and module must
not be exceeded.
G24-L Developer's Kit C-1