Factory Default Firewall Configuration; Factory Default Protection Profiles - Fortinet FortiGate FortiGate-100A Install Manual

Factory default firewall configuration

Factory default firewall configuration

Factory default protection profiles

26
FortiGate firewall policies control how all traffic is processed by the FortiGate unit.
Until firewall policies are added, no traffic can be accepted by or pass through the
FortiGate unit. The factory default configuration contains one firewall policy that
allows all traffic originating on the internal network to access the Internet. To allow
traffic through the FortiGate unit, you can add firewall policies. See the
Administration Guide for information about adding firewall policies.
The following firewall configuration settings are included in the default firewall
configuration to make it easier to add firewall policies.
Table 5: Factory default firewall configuration
Configuration setting Name
Firewall policy Internal -> External Source: All Destination: All
Firewall address All
Pre-defined service More than 50
predefined services
Recurring schedule Always
Protection Profiles Strict, Scan, Web,
Unfiltered
The factory default firewall configuration is the same in NAT/Route and
Transparent mode.
Use protection profiles to apply different protection settings for traffic controlled by
firewall policies. You can use protection profiles to:
• configure antivirus protection for HTTP, FTP, IMAP, POP3, and SMTP firewall
policies
• configure Web filtering for HTTP firewall policies
• configure Web category filtering for HTTP firewall policies
• configure spam filtering for IMAP, POP3, and SMTP firewall policies
• enable the Intrusion Protection System (IPS) for all services
• enable content logging for HTTP, FTP, IMAP, POP3, and SMTP firewall
policies
By using protection profiles, you can build protection configurations that can be
applied to different types of firewall policies. This allows you to customize types
and levels of protection for different firewall policies.
For example, while traffic between internal and external addresses might need
strict protection, traffic between trusted internal addresses might need moderate
protection. You can configure firewall policies for different traffic services to use
the same or different protection profiles.
Protection profiles can be added to NAT/Route mode and Transparent mode
firewall policies.
FortiGate-60 series and FortiGate-100A FortiOS 3.0 MR4 Install Guide
Description
Firewall address matches the source or
destination address of any packet.
Select from any of the 50 pre-defined
services to control traffic through the
FortiGate unit that uses that service.
The recurring schedule is valid at any time.
Control how the FortiGate unit applies
virus scanning, web content filtering, spam
filtering, and IPS.
01-30004-0266-20070831
Factory defaults
FortiGate