Using The Web-Based Manager; Using The Command Line Interface - Fortinet FortiGate FortiGate-100A Install Manual

Configuring the FortiGate unit

Using the web-based manager

1
2
3
4
5
1
2
3
4

Using the Command line interface

FortiGate-60 series and FortiGate-100A FortiOS 3.0 MR4 Install Guide
01-30004-0266-20070831
The method you choose depends on the complexity of the configuration, access
and equipment, and the type of interface you are most comfortable using.
Table 10: Transparent mode settings
Administrator Password:
IP:
Netmask:
Default Gateway:
Management IP
The management IP address and netmask must be valid for the
network from which you will manage the FortiGate unit. Add a default
gateway if the FortiGate unit must connect to a router to reach the
management computer.
Primary DNS Server:
DNS Settings
Secondary DNS Server:
You can use the web-based manager to complete the initial configuration of the
FortiGate unit. You can continue to use the web-based manager for all FortiGate
unit settings.
For information about connecting to the web-based manager, see
the web-based manager" on page
The first time you connect to the FortiGate unit, it is configured to run in
NAT/Route mode.
To switch to Transparent mode using the web-based manager
Go to System > Status.
Select Change beside the Operation Mode.
Select Transparent in the Operation Mode list.
Type the Management IP/Netmask address and Default Gateway address you
gathered in Table 10 on page
Select Apply.
You do not have to reconnect to the web-based manager at this time. Once you
select Apply, the changes are immediate, and you can go to the system
dashboard to verify the FortiGate unit has changed to Transparent mode.
To configure DNS server settings
Go to System > Network > Options.
Enter the IP address of the primary DNS server.
Enter the IP address of the secondary DNS server.
Select Apply.
As an alternative to the web-based manager, you can begin the initial
configuration of the FortiGate unit using the command line interface (CLI). To
connect to the CLI, see "Connecting to the CLI" on page
you gathered in Table 10 on page 41
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
18.
41.
to complete the following procedures.
Transparent mode installation
"Connecting to
19. Use the information
41