Factory Default Transparent Mode Network Configuration; Factory Default Firewall Configuration - Fortinet FortiGate FortiGate-60M Installation Manual

Getting started

Factory default Transparent mode network configuration

Factory default firewall configuration

FortiGate-60M Installation Guide
Table 3: Factory default NAT/Route mode network configuration (Continued)
Network Settings
In Transparent mode, the FortiGate unit has the default network configuration listed in
Table 4.
Table 4: Factory default Transparent mode network configuration
Administrator
account
Management IP
DNS
Administrative access
FortiGate firewall policies control how all traffic is processed by the FortiGate unit.
Until firewall policies are added, no traffic can be accepted by or pass through the
FortiGate unit. The factory default configuration contains one firewall policy that allows
all traffic originating on the internal network to access the Internet. No other traffic is
allowed through the FortiGate unit. To allow traffic through the FortiGate unit you can
add firewall policies. See the FortiGate Administration Guide for information about
adding firewall policies.
The following firewall configuration settings are included in the default firewall
configuration to make it easier to add firewall policies.
01-28008-0111-20050128
Factory default FortiGate configuration settings
Default Gateway (for default route)
Interface connected to external network
(for default route)
Default Route
A default route consists of a default gateway and the name of
the interface connected to the external network (usually the
Internet). The default gateway directs all non-local traffic to this
interface and to the external network.
Primary DNS Server
Secondary DNS Server
User name:
Password:
IP:
Netmask:
Primary DNS Server:
Secondary DNS Server:
Internal
WAN1
WAN2
DMZ
192.168.100.1
wan1
207.192.200.1
207.192.200.129
admin
(none)
10.10.10.1
255.255.255.0
207.194.200.1
207.194.200.129
HTTPS, Ping
Ping
Ping
HTTPS, Ping
21