Toshiba e-Studio2000AC Hardware Troubleshooting Manual page 61

1.TROUBLESHOOTING FOR THE HARDWARE
 Misfeed when making copies or prints (using a drawer)
Clear the paper misfeed following the guidance shown on the touch panel.
1
Open the paper source drawer, check that the guide width is correct and there is no folded/curled
2
paper or overloading, and then close the drawer.
Be sure that the height of the stacked paper does not exceed the line indicated inside of the side guides.
In particular, be sure that the upper limit for thick paper is not exceeded when placing thick paper in the first
drawer of the e-STUDIO2000AC/2500AC. The amount of thick paper you can load in the drawer is lower than that
for plain paper.
Pay attention not to exceed the upper limit of the reuse paper when you place it in the reuse paper drawer for the
e-STUDIO5008LP Series, since the amount to be placed will be less than for plain paper.
Close all the drawers or covers.
3
Clearing a Paper Misfeed 61