Selecting The Video Input - Sony ZRD-1 Operating Instructions Manual

Selecting the Video Input

Select the video signals that will be input.
The settings configured on the primary controller will be
applied to all the other display controllers, including the
subordinate controllers (hereafter referred to as "sub
controllers"). Sub controllers cannot be configured
individually.
Caution
If the a primary controller is not configured via Display
Control Software or the primary controller is not already
turned on at the time the [Input Setting] screen is
displayed, video input selection cannot be performed. In
addition, the video input settings will not be applied to the
sub controllers if they are not turned on.
1
Select [Input Settings] in the [Array] menu on the
main screen of Display Control Software.
2
Select the input channel in [Input Select], and click
[OK] or [Apply].
The video input changes.
[HDMI1] (ZRCT-200 only): Use HDMI connector 1
to display pictures.
[HDMI2] (ZRCT-200 only): Use HDMI connector 2
to display pictures.
[DVI] (ZRCT-100 only): Use the DVI connectors to
display pictures as large as 4K 50p/60p. (All four
DVI connectors are used.)
Example of picture positions and DVI
connectors:
• DVI connector 1: Top left
• DVI connector 2: Bottom left
• DVI connector 3: Top right
• DVI connector 4: Bottom right
DVI connector 1
DVI connector 2
Note
A picture can be displayed using only one DVI
connector. For details, refer to the Installation
Manual.
[DisplayPort (Single1)]: Use DisplayPort
connector 1 to display the picture.
[DisplayPort (Single2)]: Use DisplayPort
connector 2 to display the picture.
For details on the supported video signals for display,
see "Signal Formats" (page 19).
[DisplayPort (Dual)]: Use two DisplayPort
connectors to display pictures as large as 4K
100p/120p.
Note
If you are only inputting single-stream signals
that are 50p/60p or lower, we recommend
clicking [Detailed Input Settings] and clearing
the [High Frame Rate Mode] checkbox in the
[Detailed Input Settings] screen.
3
Click [OK] or [Apply] to apply the settings.
The setting values will be registered to the display
controller and saved to Display Control Software.
10
DVI connector 3
DVI connector 4