Turning The Power Off; Selecting The Video Input - Sony ZRD-1 Operating Instructions Manual

Turning the Power Off

You can turn off the system's power using one of two
methods.
• Turning the power off via the display controller
• Turning the power off via Display Control Software
Turning the power off via the display
controller
1
Turn off the video source equipment.
2
Press the power switch on the display controller
twice.
The display controller and display units will enter
standby mode.
3
If necessary, disconnect the AC power supply.
Turning the power off via Display Control
Software
1
Turn off the video source equipment.
2
Click [Standby] in the main screen of Display Control
Software.
The display controller and display units will enter
standby mode.
3
If necessary, disconnect the AC power supply.

Selecting the Video Input

Select the video signals that will be input.
The settings configured on the primary controller will be
applied to all the other display controllers, including the
subordinate controllers (hereafter referred to as "sub
controllers"). Sub controllers cannot be configured
individually.
Caution
If the a primary controller is not configured via Display
Control Software or the primary controller is not already
turned on at the time the [Input Setting] screen is
displayed, video input selection cannot be performed. In
addition, the video input settings will not be applied to the
sub controllers if they are not turned on.
1
Select [Input Settings] in the [Array] menu on the
main screen of Display Control Software.
2
Select the input channel in [Input Select], and click
[OK] or [Apply].
The video input changes.
[DVI]: Use the DVI connectors to display pictures as
large as 4K 50p/60p. (All four DVI connectors
are used.)
Example of picture positions and DVI
connectors:
• DVI connector 1: Top left
• DVI connector 2: Bottom left
• DVI connector 3: Top right
• DVI connector 4: Bottom right
9