Cleaning And Storage; Display Units; Display Controllers; Signal Formats - Sony ZRD-1 Operating Instructions Manual

Display unit display controller
Hide thumbs Also See for ZRD-1:
Table of Contents

Advertisement

Cleaning and Storage

Display Units

Caution
Do not wet the surface of the display units.
Daily cleaning
• Use a soft anti-static cloth that does not produce lint
when cleaning the surface of the display units.
(Recommended cloth: savina MX wiping cloth made by
KB SEIREN, LTD.)
• Use ethyl alcohol (near 100%) to clean stubborn stains
on the surface. Do not use any other solvents.
• Use commercially available anti-static dust blowers to
clean joints.
Storage (for transportation)
• Make sure the display units are completely dry before
packing them.
• Store the display units in dry, well-ventilated
environments.

Display Controllers

Daily cleaning
• Use a cloth that has been dampened with a neutral
detergent and thoroughly wrung out to wipe the device
clean. Never use solvents, such as benzene and thinners.
Storage
• Do not store in environments where condensation may
occur inside the device.

Signal Formats

The system supports the following video signals.

3D Inputs

Frame sequential mode
DisplayPort (single input)
Resolution
Input frame
1)
rate
2)
1920 × 2160
120p
/100p
1920 × 1080
120p/100p
DisplayPort (dual input)
Input the following input signals to DisplayPort
connectors 1 and 2.
Resolution
Input frame
1)
rate
3)
3840 × 2160
120p/100p
3D dual input mode
DisplayPort (dual input)
Input the following input signals to DisplayPort
connectors 1 and 2.
Resolution
Input frame
1)
rate
4)
3840 × 2160
60p/50p
1920 × 2160
60p/50p
1920 × 1080
60p/50p
DVI (ZRCT-100 only)
Input the following input signals to DVI connectors 1 and
3.
Resolution
Input frame
1)
rate
1920 × 1080
60p/50p
1) 1,000/1,001 frame rate is also supported for 120p/60p/30p/24p.
2) Input 1920 × 2160 signals (multi-stream only) to DisplayPort
connector 1 or 2.
3) Input 1920 × 2160 signals (multi-stream only) to DisplayPort
connectors 1 and 2.
4) Input 3840 × 2160 signals (multi-stream only) to DisplayPort
connectors 1 and 2.
19
Input bit
Input color
length
sampling
2)
8-/10-bit
RGB 4:4:4
8-/10-bit
RGB 4:4:4
Input bit
Input color
length
sampling
8-/10-bit
RGB 4:4:4
Input bit
Input color
length
sampling
8-/10-bit
RGB 4:4:4
8-/10-bit
RGB 4:4:4
8-/10-bit
RGB 4:4:4
Input bit
Input color
length
sampling
8-bit
RGB 4:4:4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zrd-2Zrct-100Zrct-200

Table of Contents