Turning The Power Off - Sony ZRD-1 Operating Instructions Manual

Note
If you press the power switch only once in the power
ON state, the POWER indicator will blink red for
2 seconds, but the standby mode will not be entered.
You can enter standby mode by pressing the power
switch again while the indicator is still blinking red.
2
Turn on the video source equipment.
Turning the power on via Display Control
Software
The initial settings must be configured beforehand to turn
the power on via Display Control Software. For details,
consult your system administrator.
1
Start the controller PC, and click [All Programs] -
[Display Control Software] - [Display Control
Software] in the start menu to start Display Control
Software.
2
Click [Power ON] in the main screen.
Under default settings, all display controllers and
display units will turn on.
When a display controller turns on, its POWER
indicator lights green.
When a display unit turns on, its status indicator lights
green.
When you click [Standby]
The power status of all connected display controllers
and display units will enter standby mode, and the
main screen will remain displayed.
Click [Power ON] to turn the power on again.
3
Turn on the video source equipment.
Turning the power on by connecting the
power cord to the display controller
When [Function] - [System Settings] - [Direct Array
Power On] is set to [ON] in Display Control Software
beforehand, simply connecting the display controller's
power cord will turn on the display controller and display
units.
1
Connect the power cord to the - IN connector on the
display controller.
When a display controller turns on, its POWER
indicator will switch from blinking red/orange to
remaining lit green.
When a display unit turns on, its status indicator lights
green.
2
Turn on the video source equipment.

Turning the Power Off

You can turn off the system's power using one of two
methods.
• Turning the power off via the display controller
• Turning the power off via Display Control Software
Turning the power off via the display
controller
1
Turn off the video source equipment.
2
Press the power switch on the display controller
twice.
The display controller and display units will enter
standby mode.
3
If necessary, disconnect the AC power supply.
Turning the power off via Display Control
Software
1
Turn off the video source equipment.
2
Click [Standby] in the main screen of Display Control
Software.
The display controller and display units will enter
standby mode.
3
If necessary, disconnect the AC power supply.
9