Turning The Power On/Off; Turning The Power On - Sony ZRD-1 Operating Instructions Manual

l DVI (video input) connectors 1 to 4 (ZRCT-100
only)
Connect these to the video processor.
m DisplayPort (video input) connectors 1 and 2
Connect these to the video processor.
n HDMI (video input) connectors 1 and 2 (ZRCT-
200 only)
Connect these to the video processor.
Caution
When inputting 4K-equivalent HDMI signals, use a
cable that is marked with the Premium High Speed
HDMI logo and is within 3 m in length.
We recommend using Premium High Speed HDMI
cables that are within 3 m in length even when you are
not inputting 4K-equivalent HDMI signals.

Turning the Power On/Off

Turning the Power On

You can turn on the system's power using one of three
methods. Consult your system administrator regarding
which method to use.
• Turning the power on via the display controller
• Turning the power on via Display Control Software
• Turning the power on by connecting the power cord to
the display controller
Caution
Always connect the display controller's power cord to the
circuit breaker.
If pictures are not displayed within 5 minutes of turning on
the system's power, try turning the system's power off and
then on again.
Note
If a startup delay is configured in the [Function] - [System
Settings] - [Display Unit Power On Delay] setting of
Display Control Software, the display units will turn on
according to the configured delay.
Turning the power on via the display
controller
1
Press and hold the power switch on the display
controller for about 2 seconds.
Turn on all the display controllers by pressing each of
their power switches.
When a display controller turns on, its POWER
indicator lights green.
When a display unit turns on, its status indicator lights
green.
To enter standby mode
Press the power switch on a display controller twice to
set the display controller and display units to standby
mode.
To return to the power ON state, press and hold the
power switch again.
8