Toshiba e-STUDIO163 Service Manual page 81

7) Setting mode
When the equipment is in each setting mode, "Fnc" is displayed in the 7-segment LED.
• Paper size setting mode
The size of the copy paper in the drawer is set in this mode.
The equipment enters into the paper size setting mode by pressing the [COPY] and [DRAWER] but-
tons simultaneously more than 2 seconds. Press the [DRAWER] button to select the drawer. Then
press the [COPY] button to select the paper size, and then press the [START] button to perform the
setting. When the setting needs to be canceled halfway, press the [FUNCTION CLEAR] button.
When a size other than the ones indicated on the control panel needs to be set, press the
[DRAWER] button to select the drawer, and then press the [COPY] button to select "OTHER", and
then key in a code for the desired size as shown below. Then press the [START] button to perform
the setting. When the setting needs to be canceled halfway, press the [FUNCTION CLEAR] button.
Paper size
A3
A4
A4-R
B4
B5
B5-R
*1
A5-R
LD
LG
LT
*1 *2: These codes can be set only when the bypass tray is used.
*2: This code can be set only for JPD models.
*3: These codes can be set only for CND models.
• Operation sound setting mode
The operation (beep) sound of this equipment is set on or off in this mode.
When the density adjustment button "light" and "dark" are pressed simultaneously more than 2 sec-
onds, the equipment enters into the operation sound setting mode. The on or off of this operation
sound is switched by pressing the [AUTO] button. When the sound is on, all of the 7 density adjust-
ment lamps are turned on. When the sound is off, all of these lamps are turned off. When the on or
off of the sound has been switched, press the [START] button to perform the setting. When the set-
ting needs to be canceled halfway, press the [FUNCTION CLEAR] button.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Code
01 LT-R
02 ST-R
03 FOLIO
04 COMPUTER
05
Postcard *
06 13"LG
07
8K
08
16K
09
16K-R
10
5 - 3
Paper size
11
12
13
14
2 15
16
*3 17
*3 18
*3 19
Code
e-STUDIO163/203
CONTROL PANEL
5