Toshiba e-STUDIO163 Service Manual page 156

[S] Drawer detection switch (SW5)
(1) Take off the damp heater unit or dummy
plate.
P.10-19 "[J] Damp heater unit (DH3) /
Dummy plate"
(2) Release the latch, take off the bracket while
lifting it up, and then disconnect the connec-
tor.
(3) Release the latch and take off the drawer
detection switch from the bracket.
[T] Registration sensor (S4)
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Release the harness from the harness clamp
and disconnect 1 connector.
e-STUDIO163/203
PAPER FEEDING SYSTEM
Connector
Drawer detection switch
Harness clamp
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
10 - 26
06/04
Latch
Drawer detection
switch bracket
Fig. 10-50
Drawer detection switch bracket
Fig. 10-51
Connector
Fig. 10-52