Description Of Operation; Warming-Up; Ready State (Ready For Copying) - Toshiba e-STUDIO163 Service Manual

4.2

Description of Operation

4.2.1

Warming-up

1) Initialization
Power ON
o Heater lamp ON
o Set number "0" reproduction ratio "100%" are displayed (LED "START" OFF)
o Fan motors ON
o Initialization of scanning system
- The CIS unit moves to the home position.
- The CIS unit moves to the peak detection position.
- The LED of CIS is turned ON.
- Peak detection (white color is detected by the shading correction plate)
- The LED of CIS is turned OFF.
- The CIS unit moves to the home position.
o Ready state (LED "START" ON)
2) Pre-running operation (Only when the temperature is at 16 °C or less)
The pre-running operation is started when the temperature of the fuser roller surface reaches a cer-
tain temperature.
o The main motor is turned ON.
- Fuser roller rotated
- Drum rotated
o Pre-running operation stops after 15 seconds.
3) When the surface temperature of the fuser roller becomes sufficient for fusing,
o Ready state (LED "START" ON)
4.2.2

Ready state (ready for copying)

Buttons on the control panel enabled
o When no button is pressed for a certain period of time,
- Set number "1" is displayed. Equipment returns to the normal ready state.
e-STUDIO163/203
GENERAL OPERATION
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
4 - 2
06/04