Toshiba e-STUDIO163 Service Manual page 146

[H] Bypass pickup solenoid (SOL2)
(1) Take off the bypass unit.
P.10-10 "[A] Bypass unit"
(2) Remove 1 screw.
(3) Release the harness from the harness clamp
and slide the pickup solenoid with the spring
upward to take it off.
Note:
When installing the bypass pickup solenoid,
be sure to place the spring between the arm
and the solenoid.
[I] Bypass pickup clutch / Bypass feed clutch
(1) Take off the bypass unit.
P.10-10 "[A] Bypass unit"
(2) Remove 1 E-ring, 1 bushing and 2 screws.
Then take off the 1 bracket and 2 gears.
e-STUDIO163/203
PAPER FEEDING SYSTEM
Bypass unit
Spring
Bypass pickup solenoid
Gear
Bushing
E-ring
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
10 - 16
Screw
Fig. 10-23
Fig. 10-24
Gear
Bracket
Fig. 10-25