Installing A Chassis; Installing A Rack Or Cabinet - Cisco Nexus 9504 Hardware Installation Manual

Installing a Chassis

•
•
•
•
•
•

Installing a Rack or Cabinet

Before you install the switch, you must install a standard four-post, 19-inch (48.3 cm) EIA data center rack
(or a cabinet that contains such a rack) that meets the requirements listed in
on page
Statement 1048-Rack Stabilization
Warning
Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor
before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over.
Statement 1018-Supply Circuit
Warning
Take care when connecting units to the supply circuit so that wiring is not overloaded.
Step 1 Bolt the rack to the subfloor before moving the chassis onto it.
Installing a Rack or Cabinet, page 13
Unpacking and Inspecting a New Switch, page 14
Installing the Bottom-Support Rails, page 15
Installing a Chassis in a Rack or Cabinet, page 17
Grounding the Chassis, page 21
Connecting the Switch to an AC Power Source, page 24
10.
C H A P T E R
Cisco Nexus 9504 NX-OS Mode Switch Hardware Installation Guide
3
Rack and Cabinet Requirements,
13