Removing A Fabric Module - Cisco Nexus 9504 Hardware Installation Manual

Removing a Fabric Module

Number of Fabric Modules
5
6 (Fully populated)
To replace a fabric module, you must perform these operations, which are explained in the topics that follow:
1 Remove the fan tray that covers the fabric module that you are replacing.
2 Shutdown and remove the fabric module.
3 Install the new fabric module.
4 Install the fan tray over the new fabric module.
Statement 1034—Backplane Voltage
Warning
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution when
servicing
Removing a Fabric Module
Before You Begin
• You must wear an electrostatic discharge (ESD) wrist strap or other ESD protective device while handling
• Prepare an antistatic surface or packing materials for each module that you remove from the chassis.
• You must remove the fan tray that covers the fabric module that you are removing (see
Step 1 If you are replacing a fabric module, open the packaging for the new module and inspect it for damage.
If the module is damaged, alert the Technical Assistance Center (TAC) and stop this replacement process until you have
an undamaged module to install.
Step 2 Remove the fan tray that covers the fabric module by following these steps:
Cisco Nexus 9504 NX-OS Mode Switch Hardware Installation Guide
72
modules.
t_n95xx_remove_fan_tray.xml.
Replacing or Installing Modules, Fan Trays, and Power Supplies
Slots to be Filled
21, 22, 23, 24, and 26, or
22, 23, 24, 25, and 26
21, 22, 23, 24, 25, and 26