Cisco Nexus 9504 Hardware Installation Manual page 29

Nx-os mode switch

Hide thumbs Also See for Nexus 9504:

Table of Contents

Installing a Chassis

Note

To lift the chassis, use a mechanical lift. Do not use the handles on the side of the chassis (the handles are not

rated for lifting over 200 pounds [91 kg]). Use the side handles for only repositioning the chassis after it is

already on the mechanical lift or in the rack or cabinet.

Step 3

Use the mechanical lift to move and align the rear of the chassis to the front of the four-post rack or cabinet.

Make sure that the bottom of the chassis is elevated to the height of the bottom-support rails or no more than 1/4 inch

(0.6 cm) above the bracket.

Step 4

Push the chassis halfway onto the rack or cabinet.

Use at least two persons to push the chassis onto the bottom-support rails and one person to guide the chassis down the

center of the rails. Push the lower half of the front side of the chassis so that the back side enters the rack first, and push

Cisco Nexus 9504 NX-OS Mode Switch Hardware Installation Guide

Installing a Chassis in a Rack or Cabinet

Table of Contents