Table of Contents
Advertisement
Figure 5.35
• By using buttons 15 or 16 (Figure 5.32) it
is possible to modify the value of param-
eter P07:
00 = probe disabled (preset)
01 = probe enabled
• Press 12 or 13 (Figure 5.32) to confirm the
value entered and return to the list of pa-
rameters Figure 5.34.
• Press the 17 button (Figure 5.32) to exit
"programming mode".
• Press 13 and hold until the LCD display
shows the code P08, indicating entry into
"parameter P08" (Figure 5.36).
Figure 5.36
• Using buttons 15 or 16 it is possible to
change the value of parameter P08 from
a minimum of 1.0 to a maximum of 3.0
based on the selected curve of the K co-
efficient in Figure 5.30 (the value read on
the display corresponds to the decimal
values of the K coefficients).
• Press 12 or 13 (Figure 5.32) to confirm the
value entered and return to the list of pa-
rameters (Figure 5.36).
• Press the 17 button (Figure 5.32) to exit
"programming mode".
At this point the system delivery tempera-
- 40 -
INSTALLATION
RESET
bar
RESET
bar
ture will follow the trend in relation to the set
K coefficient.
If the room temperature is not comfortable,
you can increase or decrease the heating
system delivery temperature by ± 5°C using
the 15 (decrease) and 16 (increase) buttons
(Figure 5.32).
With heating temperature setting 28-55°C
the temperature trend for K 1.0 is shown in
Figure 5.37, while, with temperature setting
50-80°C (factory preset), the temperature
trend for K 1.0 is shown in Figure 5.38.
Delivery temperature
°C (28-55°C)
60
55
50
+5°C
45
40
35
30
25
20
30
25
20
15
10
K=1.0
Figure 5.37
Delivery temperature
°C (50-80°C)
85
80
75
+5°C
70
65
60
55
50
45
30
25
20
15
10
K=1.0
Figure 5.38
-5°C
5
0
-5
-10 -15 -20 -25
External temperature °C
-5°C
5
0
-5
-10 -15 -20 -25
External temperature °C
Advertisement
Table of Contents
