Table of Contents
Advertisement
The manual must be read carefully to ensure rational and safe use of the boiler. It must
be stored with care as it may be necessary to consult it in the future. If the unit is trans-
ferred to another owner, the manual must accompany the boiler.
The initial switch-on must be carried out by an Authorised Service Centre. A list of these
can be found at www.biasi.it/assistenza. The validity of the warranty starts from the date
the product is purchased (see conditions listed on the specific certificate).
The manufacturer declines all liability for translations of this manual from which incorrect
interpretations may result. It cannot be considered responsible for failure to observe the
instructions contained in this manual or the consequences of any actions that have not
been specifically described.
After removing the packaging, make sure that the appliance is not damaged.
If damaged do not install or start up the appliance as it may be dangerous.
Contact your retailer or the nearest authorised service centre.
Installation must be carried out by qualified personnel who are responsible for compli-
ance with all applicable national and local laws and standards.
The boiler is used to heat water to a temperature that is lower than boiling point, and
must be connected to a heating system and/or a domestic hot water distribution network
that is compatible with its performance and power.
The boiler must be supplied with Methane gas (G20) or LPG (Propane G31).
The boiler must only be used for the purpose for which it was designed. Furthermore:
• It must not be exposed to atmospheric agents.
• This unit is not meant for use by people with reduced psychological or motor skills or
who lack experience and knowledge (including children), unless they are supervised by
a person responsible for their safety and have been properly instructed in using the unit.
• Children must be supervised to make sure they do not play with the unit.
• Prevent incorrect use of the boiler.
• Avoid making adjustments to the sealed devices.
• Avoid contact with hot parts during operation.
IMPORTANT
DURING INSTALLATION
- 3 -
Advertisement
Table of Contents
