Label; Summit48I Switch Front View; Gbic Ports - Extreme Networks Alpine 3808 Hardware Manual

Label

The label on the rear of the Summit7i switch displays important information about your switch. Write
down the following information before you install the switch:
• Model number—Shows the model number assigned to this device
• Part number—Shows the part number assigned to this device
• Serial number—Refer to the serial number when you contact Extreme Networks technical support
• MAC address—Shows the unique Ethernet MAC address assigned to this device.

Summit48i Switch Front View

The Summit48i switch is 2U in height and has 48 autosensing 10BASE-T/100BASE-TX ports and 4
1000BASE-X ports with SC connectors.
Figure 25 shows the front view of the Summit48i switch.
Figure 25: Front view of the Summit48i switch
49
49 49R
50 50R
Port status LEDs

GBIC Ports

The Summit48i switch has two Gigabit Ethernet ports and two redundant Gigabit Ethernet ports. All of
the Gigabit Ethernet ports use SC connectors. You can use the following GBICs in the Summit48i switch:
• 1000BASE-SX
• 1000BASE-LX
• 1000BASE-LX70
• ZX GBIC
• LX100
• UTP GBIC
Extreme Networks Consolidated Hardware Guide
Gigabit Ethernet ports
49R 50 50R
17 18 19 20 21 22 23 24
33 34 35 36 37 38 39 40
10/100 Mbps ports
Unit status LEDs
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
25 26 27 28 29 30 31 32
41 42 43 44 45 46 47 48
Summit48i Switch Front View
S48i_fr
77