Summit 200-48 Switch Front View; Console Port; Port Connections - Extreme Networks Alpine 3808 Hardware Manual

Summit 200-48 Switch Front View

The Summit 200-48 switch 1U in height and provides 48 autosensing 10BASE-T/100BASE-TX ports
using RJ-45 connectors. It also provides two 10/100/1000BASE-T Gigabit Ethernet uplink ports using
RJ-45 connectors and two optical ports that also allow Gigabit Ethernet uplink connections through
Extreme 1000BASE-SX, 1000BASE-LX, or 1000BASE-ZX SFP mini-GBICs using optical fibers with LC
connectors.
Figure 44 shows the Summit 200-48 switch front view.
Figure 44: Summit 200-48 switch front view

Console Port

Use the console port (9-pin, "D" type connector) for connecting a terminal and carrying out local
management.

Port Connections

The Summit 200-48 switch has 48 10BASE-T/100BASE-TX ports using RJ-45 connectors for
communicating with end stations and other devices over 10/100Mbps Ethernet.
The switch also has four Gigabit Ethernet uplink ports. These ports are labeled 49 and 50 on the front
panel of the switch. Two of the ports are 10/100/1000BASE-T ports using RJ-45 connectors. The other
two ports are unpopulated receptacles for mini-SFP GBICs, using optical fibers with LC connectors. The
Summit 200-48 switch supports the use of 1000BASE-SX, 1000BASE-LX, or 1000BASE-ZX mini-GBICs.
NOTE
Only mini-GBICs that have been certified by Extreme Networks (available from Extreme Networks)
should be inserted into the mini-GBIC receptacles on the Summit 200 series switch.
Only two of the four Gigabit Ethernet uplink ports can be active at one time. For example, you can use
both 1000BASE-T ports, both mini-GBIC ports, or a combination of one 1000BASE-T port and one
mini-GBIC.
NOTE
For information on the mini-GBIC, see "Mini-GBIC Type and Hardware/Software Support" on page 20.
Extreme Networks Consolidated Hardware Guide
10/100 Mbps ports
Summit 200-48 Switch Front View
Console
Mini-GBIC ports port
1000-baseT ports
LC48001
101