Summit 200-48 Switch Leds - Extreme Networks Alpine 3808 Hardware Manual

• Serial number—Refer to the serial number when you contact Extreme Networks technical support
• MAC address—Shows the unique Ethernet MAC address assigned to this device
NOTE
The Summit 200-48 switch certification and safety label is located on the bottom of the switch.

Summit 200-48 Switch LEDs

Table 33 describes the LED behavior on the Summit 200-48 switch.
Table 33: Summit 200-48 switch LED behavior
Unit Status LED (MGMT LED)
Color
Green solid
Green blinking
Amber
Fan LED
Color
Green
Amber blinking
Port Status LEDs (Ports 1–50)
Color
Green
Green blinking
Off
Media-Selection (Fiber) LEDs (Ports 49 and 50)
Color
Green
Off
NOTE
For more information about configuring and using the Summit200-48 switch, see the Summit 200 Series
Switch Installation and User Guide.
Extreme Networks Consolidated Hardware Guide
Indicates
The Summit switch is operating normally.
The Summit switch POST is in progress.
The Summit switch has failed its POST or an overheat condition
is detected.
Indicates
The fan is operating normally.
A failed condition is present on the fan.
Indicates
Link is present; port is enabled.
Link is present, port is enabled, and there is activity on the port.
Link is not present or the port is disabled.
Indicates
Fiber link is selected; mini-GBIC is present and being used for the
Gigabit Ethernet uplink.
1000BASE-T link is selected; the switch is using the RJ-45 port
for the Gigabit Ethernet uplink.
Summit 200-48 Switch LEDs
103