Removing The Ac Power Cable Retaining Bracket From A Power Cable - Extreme Networks Alpine 3808 Hardware Manual

Summit Switch Installation
6 Tighten the retaining bracket screw.
If your switch has two power supplies, install the second retaining bracket now by repeating the
preceding steps. Align the retaining brackets as shown in Figure 52 so that the retaining bracket
screws do not interfere with each other.
Figure 52: Attaching two retaining brackets
Retaining bracket screw
Retaining bracket screw
7 Connect the power cable(s) to the power source.
Removing the AC Power Cable Retaining Bracket from a
Power Cable
Before you can remove a power cable from the power supply, you need to loosen the retaining bracket
from the cable.
To remove the AC power cable retaining bracket from a power cable:
1 Disconnect the power cable from the power source.
2 Loosen the retaining bracket screw.
To locate the retaining bracket screw, see either Figure 51 or Figure 52.
3 Gently remove the power cable from the power supply.
If you are installing a replacement power supply for the Summit48si switch, see "Removing and
Installing Summit48si Power Supplies" on page 109 for installation procedures. After you install the
replacement power supply, you need to install a new AC power cable retainer. See "Installing the AC
Power Cable Retaining Bracket" on page 111 for more details.
If you are installing a replacement power cable, you need to tighten the AC power cable retaining
bracket to the new power cable.
112
SH_002
Extreme Networks Consolidated Hardware Guide