Cisco FM3200 Base Installation And Configuration Manual page 35

Figure 9. Protective rubber sleeves
Connect the antennas to the unit by doing the following steps:
1. The number and types of antennas to be connected to the unit
will have been decided at the network design stage. Verify which
antenna will be connected to each RPSMA plug.
2. Only remove the rubber sleeve from an RPSMA plug if an
antenna must be connected to the plug.
Next, proceed to the steps in the following table:
3. Check the round, knurled nuts of the
RPSMA connectors for tightness. If any
round nuts are loose, tighten them by
hand only.
© 2021 Cisco and/or its affiliates. All rights reserved.
Hardware installation
4. Slide a section of Nylon heat-shrinkable tubing
over each unconnected antenna cable.
5. Push the male RPSMA plug of the antenna
cable into the female RPSMA plug of the unit.
6. Screw the threaded sleeve of the male plug
onto the female plug. Tighten the connection by
hand only.
7. Slide the lengths of Nylon heat-shrinkable
tubing over the tightened RPSMA connectors.
8. Use a heat gun to shrink the tubing onto the
connectors.
Page 35 of 176