Table of Contents
Advertisement
Quick Start Guide
FCC Statement (U.S.A.)
The United States Federal Communications Commission has specified that the
following notice be brought to the attention of users of the ENCAD printers.
FEDERAL COMMUNICATIONS COMMISSION RADIO AND TELEVI-
SION INTERFERENCE FOR CLASS A DEVICE
Statement
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio frequency energy, and
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
User Instructions:
If the equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment on and off, the user is encour-
aged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by ENCAD, Inc. could void the
user's authority to operate the equipment.
Note: This product was FCC certified under test conditions that included the use
of shielded I/O cables and connectors between system components. To be in
compliance with FCC regulations, the user must use shielded cables and connec-
tors and install them properly.
2
Advertisement
Table of Contents
