Internal Usb Memory Key (Optional) - Dell EMC PowerEdge R730xd Owner's Manual

Figure 73. Installing the NDC
1. captive screw socket (2)
3. captive screw (2)
5. network daughter card (NDC)
Next steps
1. If applicable, install the expansion card(s) in the expansion card riser 2.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system
Removing an expansion card from expansion card riser 2 or 3
Installing an expansion card into the expansion card riser 2 or 3
After working inside your system

Internal USB memory key (optional)

An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device.
To boot from the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in
the boot sequence in System Setup.
The internal USB port must be enabled in Internal USB Port option in the Integrated Devices screen of System Setup.
on page 68
on page 68
2. connector on the system board
4. touch point (2)
6. back panel slot for Ethernet connectors
on page 117
on page 118
Installing and removing system components 139