Chapter 4: Initial System Setup And Configuration; Setting Up Your System; Idrac Configuration; Options To Set Up Idrac Ip Address - Dell EMC PowerEdge R730xd Owner's Manual

Initial system setup and configuration
Topics:
•

Setting up your system

•

iDRAC configuration

•
Options to install the operating system
•
Manage your system
Setting up your system
Complete the following steps to set up your system:
Steps
1. Unpack the system.
2. Install the system into the rack. For more information about installing the system into the rack, see your system Rack
Installation Placemat at Dell.com/poweredgemanuals.
3. Connect the peripherals to the system.
4. Connect the system to its electrical outlet.
5. Turn the system on by pressing the power button or by using iDRAC.
6. Turn on the attached peripherals.
iDRAC configuration
The Integrated Dell Remote Access Controller (iDRAC) is designed to make system administrators more productive and improve
the overall availability of Dell EMC systems. iDRAC alerts administrators to system issues, helps them perform remote system
management, and reduces the need for physical access to the system.

Options to set up iDRAC IP address

You must configure the initial network settings based on your network infrastructure to enable the communication to and from
iDRAC. You can set up the IP address by using one of the following interfaces:
Interfaces Document/Section
See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals
iDRAC Settings
utility
See Dell Deployment Toolkit User's Guide at Dell.com/openmanagemanuals
Dell Deployment
Toolkit
See Dell Lifecycle Controller User's Guide at Dell.com/idracmanuals
Dell Lifecycle
Controller
You must use the default iDRAC IP address 192.168.0.120 to configure the initial network settings, including setting up DHCP or
a static IP for iDRAC.
To access iDRAC, ensure that you install the iDRAC port card or connect the network cable to the Ethernet
NOTE:
connector 1 on the system board.
Ensure that you change the default user name and password after setting up the iDRAC IP address.
NOTE:
34 Initial system setup and configuration
4