Removing A Processor - Dell EMC PowerEdge R730xd Owner's Manual

Figure 38. Removing a heat sink
1. retention screw (4)
3. processor shield
Next steps
1. Replace the heat sink(s) and processor(s).
2. Replace the processor and heat sink.
3. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system
Removing an expansion card from expansion card riser 2 or 3
Removing the cooling shroud

Removing a processor

on page 100
Installing a processor on page 104
Installing a heat sink on page 106
Installing the cooling shroud
Installing an expansion card into the expansion card riser 2 or 3
After working inside your system
Removing a processor
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell
NOTE:
certified service technicians.
If you are upgrading your system, download the latest system BIOS version from Dell.com/support and follow the
NOTE:
instructions included in the compressed download file to install the update on your system.
100 Installing and removing system components
on page 68
on page 75
on page 76
on page 68
2. heat sink
4. retention screw slot (4)
on page 117
on page 118