15. Install screws, washers, and pivot shaft securing the left lower work arm assembly to the left upper work arm
assembly using a 7mm Allen wrench.
16. Repeat Step 15 to install the right lower work arm assembly to the right upper work arm assembly.
Install Front Shrouds
OPTIONAL: The following procedure shows how to install the optional front shrouds. If your product does not include
front shrouds, skip this procedure.
1. Set front shrouds into the grooves on the bottom cap and then flex them into place in the top cap.
2. Press front shrouds in behind the shroud retainer grommets.
Item
1
Lower Work Arm Assembly, Left
2
Upper Work Arm Assembly, Left
3
4
5
Screw, M10 x 1.5, 25mm, Low Head with
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Item
1
2
Page 25 of 34
Description
Pivot Shaft
Washer, .375"
Loctite
Description
Front Shroud, Left
Front Shroud, Right
Qty.
1
1
1
2
2
Qty.
1
1