5. Repeat Steps 1-4 to install the right upper work arm assembly
6. Route one end of the cable into the right cam assembly.
7. Install cable retainer securing the cable to the right cam assembly.
8. Install screws, washers, and locknuts securing the cable retainer cover plate to right cam assembly using an 8mm
Allen wrench and a 17mm wrench.
NOTE: Make sure the work arm is engaged in detent position "3" to easily access the screws.
Item
1
2
3
4
Cable Retainer Cover Plate
5
6
7
Nut, M10 x 1.5, Hex Nylock
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Page 22 of 34
Description
Cable
Cam Assembly, Right
Cable Retainer
Screw, M10 x 1.5, 50mm
Washer, Flat 3/8"
Qty.
1
1
1
1
2
2
2