5. Install screws securing seat glide bushing to main frame using a Phillips screwdriver.
6. Install screws and washers securing the overhead frame assembly to the tower frame using an 8mm Allen wrench.
7. Install screws, washers, and locknuts securing the pulleys to the pulley brackets on the tower frame using an 8mm
Allen wrench and a 17mm wrench.
Item
1
2
3
4
Tighten hardware to 30-39 in-lb (3.4-4.4 Nm).
Item
1
Overhead Frame Assembly
2
3
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Item
1
2
3
4
5
Nut, M10 x 1.5, Hex Nylock
Tighten hardware to 8-10 ft-lb (10.8-13.5 Nm).
Page 13 of 34
Description
Seat Post Assembly
Seat Glide Bushing
Seat Frame
Screw, M5 x 10, Phillips
Description
Screw, M10 x 1.5, 25mm
Washer, Flat 3/8"
Description
Pulley, 3.5" OD
Screw, M10 x 1.5, 45mm
Screw, M10 x 1.5, 50mm
Washer, Flat 3/8"
Qty.
1
1
1
2
Qty.
1
8
8
Qty.
4
2
2
6
2