Ground/Platform/Off Key Selector Switch; Platform Lift/Lower Switch; Inverter On/Off Switch (If Equipped) - JLG R4045 Operation And Safety Manual

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
DO NOT OPERATE FROM GROUND CONTROL STATION WITH PERSONNEL IN THE PLAT-
FORM EXCEPT IN AN EMERGENCY.

Ground/Platform/OFF Key Selector Switch

The key selector switch on the
Ground Control Station functions to
direct electrical power to the desired
control station. With the switch
turned to the ground position (1),
power is supplied to the controls at
the ground control station. When the
switch is turned to the platform posi-
tion (2), power is supplied to the con-
trols at the platform control station.
The switch should be set to the OFF
position (3) when not using machine
or parking the machine overnight.
3-6

Platform Lift/Lower Switch

A three position, momentary contact lift control
switch provides raising and lowering of the plat-
form from the Ground Control Station.
NOTE: There will be a brief delay between switch
activation and movement of the plat-
form.
2
When operating platform from the ground con-
trols, activate the lift/lower switch to up position and hold to raise plat-
form, or down position and hold to lower an elevated platform. Release
to stop all movement.
3

Inverter ON/OFF Switch (If Equipped)

When switched on the inverter converts the DC voltage stored in the
on-board batteries to AC voltage for use at the AC receptacle outlet
mounted on the platform rail.
1
31215942