Table of Contents
Advertisement
Modify Pin
-
Enter the SETTING MENU.
-
Select the "Pin Code" option and press ENTER
button.
-
Select the "Modify Pin" option (Fig 64) and press
ENTER button.
The display shows the message "Old Pin" and the
spaces to enter the four digits of the old pin (Fig 62).
The two arrows above and below the first digit give
the possibility to set it. Entering the code:
-
Use UP and DOWN buttons to increase and
decrease by 1 the value from "0" to "9".
-
Press ENTER button to confirm the digit and
move on to the following digit.
-
Repeat the procedure until entering all 4 digits.
Once the fourth digit is set, press ENTER and the
instrument panel behaviour will be as follows:
-
if the pin code is not correct, the instrument
panel displays "Wrong" highlighted in red for 2
seconds and then goes back to previous screen,
to allow you to try again;
-
if the pin code is correct, the instrument panel
shows "Correct" highlighted in green for 2
seconds, and then displays the page for entering
< Back
Modify Pin
...
Old Pin
0 - - -
...
Fig 64
Fig 65
97
Advertisement
Table of Contents
