Menu List - Sony HDCU1700 Operation Manual

Menu List

Note
The following conventions are used in the menu list table.
Settings column values (e.g. ON, OFF, 0): Default settings
Execute via ENTER: Press the CONTROL knob or move the CANCEL/ENTER lever to the ENTER position to execute.
SYSTEM OPERATION menu
SYSTEM OPERATION
Page name Item
Page No.
<OUTPUT SELECT> OUTPUT
S01
PIX
WFM
<GENLOCK PHASE> CONTROL
S02
REFERENCE
GENLOCK
Settings
CAMERA, BAR, TEST1, TEST2
ENC, R, G, B, R&G, G&B, R&B,
RGB
ENC, R, G, B, SEQ, R&G, G&B,
R&B, RGB
(REMOTE), (LOCAL)
(NONE), (EXT IN)
HD, SD
(OK), (NG)
External reference signal format
H STEP When GENLOCK mode is HD:
–3.01 to 3.45 µsec 0.00
When GENLOCK mode is SD:
–8.29 to 9.48 µsec 0.00
COARSE –99 to 99, 0
SC PHASE 0 to 359
Note
Displayed only
when HKCU1003
is connected
V PHASE 0 to 7
SUB-REF (NONE), (EXT IN)
Note
(UNKNOWN), (Frame Gate), (HD),
(SD)
Displayed only
when HKCU1003
is connected
Description
Selects the output signal.
TEST1 and TEST2 are not selectable if there is no
communication with the camera.
Selects the PIX connector output signal.
Selects the WFM connector output signal.
Displays the status of the reference signal input.
This unit's GEN LOCK mode: displays the lock
status and format.
HD: HD
SD: SD
Sets the lock status of the external reference signal.
(OK): Locked
(NG): Unlocked
Displayed only when a reference signal is present.
Horizontal phase (STEP)
Displays the sub-reference signal format.
Horizontal phase
Displays the sub-reference signal format.
Adjusts the subcarrier phase of the SD analog
signal.
Vertical phase (line)
Displays the sub-reference signal format.
Displayed only when a sub-reference signal is
present.
Sub-reference signal format display.
26