Settings Using The Menu Of The Unit; Changing Menu Item Settings - Sony HDCU5000 Operating Instructions Manual

IP stream status
Displayed only when HKCU-SFP50 is installed.
* IP S t r e a m *
OU T V I D E O 1
V I D E O 2
V I D E O 3
- - - - -
A U D I O
H D T R U N K A U D I O
I N T E R C O M
M E T A 1
M E T A 2
M E T A 3
- - - - -
Displays the stream status during IP transmission.
OUT: Outgoing IP stream
IN: Incoming IP stream
-----: No incoming/outgoing stream
Warning display
* Al a r m *
CC U : P S F A N S T O P
CC U : G E N L O C K E R R O R
Displays any warning that occurs.
1 0 / 1 1
I N R E T U R N 1
R E T U R N 2
R E T U R N 3
- - - - -
P G M
I N T E R C O M
1 1 / 1 1
Settings Using the Menu
of the Unit
The CCU system and peripheral settings can be checked and
modified using a video monitor connected to the
CHARACTER, SDI OUT 3, or SDI OUT 4 connector.
Note
To use the SDI OUT 3 or SDI OUT 4 connector, set SYSTEM
CONFIG t <OUTPUT FORMAT1> t SDI-OUT3 or
SDI-OUT4 t MONITOR in the setup menu to M.

Changing Menu Item Settings

The menu screen is controlled using the knob and levers in the
MENU control block on the front panel. Setting the CANCEL/
ENTER lever to the ENTER position and pressing the
CONTROL knob perform the same function.
DISP/MENU lever and indicator
CANCEL/ENTER lever
CONTROL knob
To display a menu page
Set the DISP/MENU lever to the MENU position.
When first powered on, the CCU MENU page is displayed.
When <OUTPUT FORMAT1> t SDI-OUT4 t MONITOR is
set to C (characters are not added), you can hold the DISP/
MENU lever in the MENU position for 3 seconds to force
display of the CCU MENU.
To display the CCU MENU page
In menu display mode, turn the CONTROL knob to move the
pointer (,) to TOP in the upper right corner of the menu
page, then press the CONTROL knob. The CCU MENU
showing the menu configuration is displayed.
** CCU MENU **
SYSTEM CONFIG
VIDEO/MONITOR
AUDIO/INTERCOM
MAINTENANCE
FILE
NETWORK
DIAGNOSIS
19