Appendix; Notes On Use; Error Messages - Sony HDCU1700 Operation Manual

Appendix

Notes on Use

Use and storage locations
Avoid using or storing the unit in the following places:
• Where it is subject to extremes of temperature (operating
temperature: –10 to +40°C (14 to 104°F)). Note that in
summer the temperature in a car with the windows closed
can reach 50 °C (122 °F).
• Very damp or dusty places.
• Where rain is likely to reach the unit.
• Places subject to severe vibration.
• Near strong magnetic fields.
• Near transmitting stations generating strong radio waves.
Avoid violent impacts
Dropping the unit, or otherwise imparting a violent shock to it,
is likely to cause it to malfunction.
Do not cover with cloth
While the unit is in operation, do not cover it with a cloth or
other material. This can cause the temperature to rise, leading
to a malfunction.
After use
Set the POWER switch on this unit to the OFF position.
Care
If the body or panels of the unit become dirty, wipe them with
a dry cloth. For severe dirt, use a soft cloth steeped in a small
amount of neutral detergent, then wipe dry. Do not use volatile
solvents such as alcohol or thinners, as these may damage
the finish.

Error Messages

When an error is detected in this unit or the camera, the
ALARM indicator turns on and an error message is displayed
on this unit.
Error message
CCU:GEN LOCK NG
CCU:DRX NG
CCU:SDI NG
CCU:PS FAN NG
CCU:PS CABLE SHORT
CCU:PS CABLE OPEN
CCU:PS RCP PWR SUPPLY
NG
CCU:RX WARNING
CCU: CAM INVALID FORMAT
CCU:DPR NG
CCU:DPR FAN NG
39
Indication
External reference sync error
Front DRX board power supply,
PLD error
Rear SDI board power supply
error
Power supply block fan error
CAMERA connector optical fiber
cable short circuit error
CAMERA connector optical fiber
cable open circuit error
Remote control panel
(connected to REMOTE
connector) power supply error
Transmission error between
camera and CCU
An invalid format is selected.
Front DPR board power supply,
PLD error
DPR board fan error