Setting Up Additional Computers - Epson Stylus C82WN Setup And Installation Manual

If it fails to print, try the following:
Make sure that the printer and print server are connected and that
both are on.
Check the printer to see if a red light is on or flashing, indicating that paper or
ink is out, or paper is jammed. See Printer Basics for details.
Check WP-Admin to make sure you have a signal (see page 20).
Make sure you entered the correct IP address and server name in step 5.
Now you're ready to print. For instructions, see Printer Basics.

Setting Up Additional Computers

You need to install the EPSON Stylus C82WN printer driver and status monitor and
configure a network port on every computer using the printer.
For computers on a wired network that has a wireless access point, skip to step 3.
For computers that have wireless network interfaces, follow all of these steps:
1. Make sure your computer's wireless mode is set to either
are connecting to the printer through an access point, or
are connecting without an access point.
If your wireless adapter doesn't include an
,
Hoc Computer-to-Computer
communicate without an access point. Do not select a pseudo ad hoc or
proprietary ad hoc mode.
2. If you're using infrastructure mode, make sure there is a link with good signal
strength between the computer and the access point.
3. Follow steps 1 through 7 starting on page 16.
4. If you're using Windows Me, 98, or 95, double-click
Print Utility
instructions to install the utility.
5. Go to page 25 and follow the appropriate set of instructions for setting up a
network port.
30
Configuring Wireless Printing for Windows
, or whatever mode your adapter uses to
on the EPSON Installation Program screen and follow the
Infrastructure
802.11b Ad Hoc
option, select
802.11b Ad Hoc
Install EpsonNet Direct
, if you
if you
Ad