Epson Stylus C82WN Setup And Installation Manual page 60

SSID
Name that identifies your wireless network, equivalent to the network name on
Macintosh. When you configure the print server in WP-Admin, it automatically
detects the SSID (Service Set Identifier) for the wireless network. The SSID must
match for all nodes on the network for them to communicate. The maximum number
of characters that you can use in this field is 32.
Wireless Mode
Mode used by computers on a wireless network to communicate with the print server.
WP-Admin detects this setting automatically, based on the mode set in your wireless
adapter configuration software. To communicate, all computers must be set to the
same wireless mode (or its equivalent, depending on your wireless adapter) as the
print server.
Infrastructure
with the print server through an access point or base station.
Ad Hoc (802.11b)
communicate with the print server directly, without using an access point or base
station.
Pseudo Ad-Hoc
adapter configuration software or on the Wireless Server Configuration screen.
—Default factory setting. Auto mode attempts connection with each of the
Auto
other methods in turn. This mode enables the print server to detect all your other
wireless network settings (for example, IP address, SSID, workgroup, etc.).
If you move your print server to a different wireless network, you must press the
test button on the back of the print server for at least five seconds to reset it to its
factory defaults (including
settings for the new network.
WEP Key
Disables or enables WEP (Wired Equivalent Privacy), which provides a level of
security for your network. To communicate, all nodes on your network must be
WEP-enabled and must use the same WEP key. See the documentation for your
wireless adapter or access point for more information about WEP. If you have an
AirPort network, see page 48.
56
Appendix A: Configuration Settings
—Used when computers on the wireless network communicate
—Used when computers on the wireless network
—Used for testing. Don't select this mode in your wireless
mode). This enables the print server to detect the
Auto