Epson Stylus C82WN Setup And Installation Manual page 23

4. Connect the power supply to the print server.
5. Plug the AC adapter into an electrical outlet.
Both the green and yellow lights come on for a
moment and then go out.
Note: If the green light blinks continuously in a
regular pattern, try unplugging the print server. If
you still see the light blinking after you plug it in
again, contact EPSON as described on page 52.
6. Press the P power button on the printer to turn
it on.
7. To test the connection between the print server and printer, press the test button
for one second and release it.
The status page prints.
Note: If you hold the test button down, you may reset
the print server. If you do this, wait for the print
server's lights to go out, then press the button again
and release it immediately to print the status page.
If the print server status page prints, you're
ready to configure your system for wireless
printing. Make sure you save the status page for
reference, and see the next section for
instructions.
If the status page doesn't print, make sure the printer is ready and is not out of
ink or paper. (See page 11 for instructions on running a printer check.) Then
turn off the printer, unplug the print server, and check the cable connections
at both ends. Plug the server back in, turn on the printer, and press the test
button again. If the test page still doesn't print, contact EPSON as described
on page 52.
Configuring Wireless Printing for Windows
19