Epson Stylus C82 Start Here

EPSON Stylus
Start
Start
Here
Here
1
1
Unpack
Unpack
1
Remove everything from the box.
Paper support
Printer
CD-ROM
Ink cartridges
2
Remove all the blue tape and packing material inside and around the printer.
The tape may be in slightly different places on your printer, so check carefully.
3
Slide the paper support into the
grooves on either side of the sheet
feeder. The paper support should
fit securely.
2
2
Power On
Power On
1
Plug the printer's power cord into a grounded electrical outlet.
C82
®
2
Press the printer's
CAUTION: Use only the printer's
3
3
Load Ink
Load Ink
1
Lower the printer's output tray
and open the cover.
CPD-14293R1
4025621-01
2
Shake the package of ink cartridges four or five times. Then remove the cartridges
from the package. (Don't shake them after removing the packaging.)
3
Lower each ink cartridge into its holder with the green circuit board facing the back.
Then gently push each ink cartridge down until it is firmly seated.
The color of the cartridge label should match the marker on the holder.
Manual
4
Press the
The green power light flashes as your printer charges ink for about 90 seconds.
CAUTION: Don't turn off the printer while the green power light is flashing,
unless the printer hasn't moved or made any noise for more than 5 minutes.
power button until the green power light comes on.
Power button
power button to turn the printer on or off.
Don't touch the
green circuit boards
or remove any labels
ink button and close the printer cover.
Ink button
4
4
Connect the Printer
Connect the Printer
Printer cables are not included with your printer. You need only one
of the following cables:
• USB cable (PC or Macintosh ® ) or
• Parallel cable (PC only).
NOTE: If you have Windows ® 95 or NT 4.x, you must use a parallel cable.
USB Cable Users (PC or Mac)
1
Shut down your computer. In Windows, click Start and select your Shut Down
or Turn Off option.
Leave your computer turned off until section 6.
2
Plug the square end of the cable into the USB port on the side of the printer.
(It's right above the parallel port.)
3
Plug the flat end of the cable into your computer's USB port until it stops.
(You can use any open USB port.)
Flat end Square end
Parallel Cable Users (PC only)
1
Shut down your computer. Click Start and select your Shut Down or Turn Off option.
Leave your computer turned off until section 6.
2
Plug the end of the cable with the slotted connector into the parallel port on the side
of the printer, then secure it with the wire clips.
3
Plug the end of the cable with the screws on the side into your computer's
parallel port and secure it.
End with screws Slotted end
Turn over