Loading Paper; Running A Printer Check - Epson Stylus C82WN Setup And Installation Manual

Loading Paper

1. Fan a few sheets of paper and place them
against the right edge guide. Don't push
the paper in.
2. Slide the left edge guide against the paper,
but not too tightly.
Don't load paper above the arrow inside
the edge guides.
Make sure the paper lies flat against the
paper support.
3. Pull out the output tray extensions.

Running a Printer Check

Before you connect the printer, print a test page to make sure the printer is working
properly. Make sure letter-size or larger paper is loaded in the printer.
1. Press the P power button to turn off the printer.
2. Hold down the ) paper button as you press and release the P power button.
3. Continue holding down the ) paper button until the P power light starts
flashing, then release it.
The printer prints a sheet showing its ROM version number, ink counter, and a
nozzle check pattern.
If the test page doesn't print, check for any red lights on the printer. See the "Problem
Solving" chapter in the Printer Basics book for guidelines. If none of the solutions
work, contact EPSON as described on page 52.
Once the printer is set up and has ink and paper, you're ready to install the software
and connect the print server. See the next section for instructions.
Don't load paper above the arrow
Setting Up Your Printer
11