Configuring The Print Server - Epson Stylus C82WN Setup And Installation Manual

Epson stylus c82wn: install guide
Hide thumbs Also See for Stylus C82WN:
Table of Contents

Advertisement

8. Check the following information on the status page:
Note the WiFi Channel and Mode, and the Actual SSID. If the SSID does
not match your network, your print server may be picking up signals from
somewhere else. You can correct this when you configure the print server.
Under NETWORK STATISTICS, make sure you see numbers indicating
that the print server has received and transmitted data. If only zeroes appear,
your print server may not be working correctly. Try holding down the print
server's test button for at least five seconds to reset it
contact EPSON as described on page 52.
9. Continue with the following instructions to configure the print server.

Configuring the Print Server

After your print server is set up and plugged in, you're ready to configure it for your
network.
1. On the Wireless Server Search screen click
START.
WP-Admin picks up the signal from the print server and displays information like
the following:
This information
appears when the
server is found
Note: If WP-Admin fails to pick up a signal from the print server, try holding down
the print server's test button for at least five seconds to reset it. The lights go out,
then both the green and yellow lights come on briefly. The yellow light remains
on when your network has a connection to the print server.
If it still fails to pick up a signal, check the solutions beginning on page 44.
20
Configuring Wireless Printing for Windows
If it is still not working,
.
This number
indicates the
signal strength

Advertisement

Table of Contents
loading

Table of Contents