Grizzly G0941 Manual page 9

13. Remove arbor nut and arbor flange from
arbor, slide on included 10" saw blade, mak-
ing sure teeth face front of saw, then install
arbor flange and arbor nut onto blade.
14. Put on heavy leather gloves and use included
arbor wrenches to tighten arbor nut (turn
clockwise to tighten), as shown in Figure 16,
then lower blade fully.
Figure 16. Example of securing blade.
15. Place fence guide tube over front rail and
secure with (7) M8-1.25 x 12 hex bolts (see
Figure 17).
Front Rail
Fence Guide
Figure 17. Fence guide tube attached to front
rail.
16. Mount fence on front rail to right of blade.
Model G0941 (Mfd. Since 09/20)
x 7
Tube
17. Install fence storage brackets (see Figure
18) onto back of cabinet with (2) M8-1.25 x
12 hex bolts.
Brackets
Figure 18. Fence resting brackets installed.
18. Install fence knob onto fence, as shown in
Figure 19.
Fence
Knob
Figure 19. Fence knob installed.
19. Install miter gauge handle and 8mm flat wash-
er onto miter gauge, as shown in Figure 20.
Figure 20. Example of miter gauge assembled.
20. Slide miter gauge into T-slot on left side of
blade; or store it on storage brackets near
blade angle handwheel.
Refer to Page 29 of the G0651/G0652 manual for
Dust Collection information then refer to Pages
31–32 to complete machine setup.
x 2
Handle
Washer
-9-