Table of Contents
Advertisement
11. Fasten the shelf end plate to the legs with
four m6-1 x 12 phillips head screws and 6mm
flat washers, as shown in Figure 21.
x 4
Figure 21. installing shelf end plate on extension
table legs.
12. place the shelf brackets between the cabinet
and support legs, and fasten with two m6-1
x 12 phillip head screws, two m6-1 x 12 hex
bolts, four 6mm flat washers and two m6-1
hex nuts, as shown in Figure 22.
Note: The flange on the shelf bracket must
point up to ensure proper installation.
shelf Bracket
x 2
Figure 22. shelf brackets installed.
13. place the lower shelf on the brackets.
14. turn the outfeed table upside down and
place it on a level surface.
model g0651/g0652 (mfg. since 1/10)
Flange
x 2
15. repeat Steps 8-11 to install the feet, sup-
port legs, and shelf end plate on the outfeed
table.
16. place the outfeed extension table assembly
upright with the feet on the ground, align the
slots in the extension table bracket with the
rear rail mounting holes, then fasten the table
to the rail with two m8-1.25 x 20 hex bolts,
8mm flat washers, and m8-1.25 hex nuts, as
shown in Figure 23.
Figure 23. outfeed table fastened to rear rail.
17. secure the lower shelf brackets to the sup-
port legs and cabinet, using the same fasten-
ers as in Step 12.
18. install the lower shelf on the brackets.
19. place the 91
/
" fence tube over the 91
1
2
front rail and secure with nine m8-1.25 x 12
hex bolts with 8mm flat washers, as shown in
Figure 24.
handwheel
handles
Figure 24. Fence tube mounted to front fence
rail.
20. install the handwheel handles, as shown in
Figure 24.
Bracket
x 2
/
1
x 9
-27-
"
2
Advertisement
Table of Contents
