Table of Contents
Advertisement
See Head-Up Display (HUD) on page 4 38 for more
information.
Make sure the set speed is visible on the HUD so you
know the speed your vehicle will accelerate to if a
vehicle is not detected in your path. Keep in mind speed
limits, surrounding traffic speeds, and weather
conditions when adjusting your set speed.
If your vehicle is in Adaptive Cruise Control when the
traction control system begins to limit wheel spin, the
Adaptive Cruise Control will automatically disengage.
See Traction Control System (TCS) on page 5 9,
®
StabiliTrak
System on page 5 6 or Enhanced
®
StabiliTrak
on page 5 7. When road conditions allow
you to safely use it again, the Adaptive Cruise Control
can be turned back on.
This symbol appears on
the Head-Up Display
(HUD) to indicate that
Adaptive Cruise Control
is active. The number
indicates the set speed.
There are two ways to increase the set speed:
Use the accelerator to get to the higher speed.
Press
at the end of the lever, then release the
button and the accelerator pedal. The vehicle will
now cruise at the higher speed.
Move the Adaptive Cruise Control switch
from to
. Hold it there until the desired set speed
is displayed in the HUD, then release the switch.
To increase the set speed in small amounts, move
the switch briefly to resume/increase. Each time
this is done, the vehicle set speed increases by
about 1.6 km/h (1 mph).
Your vehicle will not reach the set speed until the
system determines there is no vehicle in front of you.
At that point, your vehicle speed will increase to the
set speed.
4-19
Advertisement
Table of Contents
