Fiber Gpim Connections - Enterasys SmartSwitch 6G302-06 Installation Manual

Connecting the 6G306-06 to the Network
Figure 3-15 Fiber GPIM Connections
3. At the other end of the fiber optic cable, attach the SC connector to the other device. Verify that
a link exists by checking that the port Receive LED is ON (flashing amber, blinking green, or
solid green). See
LED is not blinking amber, perform the following steps until it is ON:
a. Check that the device at the other end of the link has power turned on and is Gigabit Ethernet
compatible.
b. Verify proper crossover of fiber strands between the port on the module and the fiber optic
device at the other end of the fiber optic link segment.
c. Verify that the fiber cable meets the specifications outlined in
GPIM.
3-20 Installation
Figure 3-16 for LED locations. If the Receive LED is OFF and the Transmit
Appendix C for the installed