Lanview Leds - Enterasys SecureStack C2 C2G170-24 Hardware Installation Manual

Figure 4-2

LANVIEW LEDs

LED Color
CPU Off
Red
Amber
Green
DOWN Off
Green
State
Power disconnected.
Solid. Boot-up failed.
Solid. Diagnostics are running.
Blinking. Code image is being downloaded.
Solid. System is fully functional.
Blinking. Boot-up in process.
No valid connection to switch stackup connector.
Solid. Valid connection to switch stackup
connector.
Blinking. Information is being transferred via the
high-speed stacking cable.
Recommended Action
If the LED remains off after connecting AC
power or DC power from an RPS, check
the following:
1. Make sure there is power at the
power source (AC source and RPS if
applicable).
2. Replace the power cord with a known
good one or check the continuity of
the power cord.
3. If the switch still does not power up,
the system may have a fatal error.
Contact Enterasys Networks for
technical support.
If the LED remains red for several
minutes, the system may have a fatal
error. Contact Enterasys Networks for
technical support.
If the LED remains amber for more than
several minutes, contact
Enterasys Networks for technical support.
None.
None.
None.
1. Make sure the switch connected to
the stackup connector is powered on.
2. Replace cable with a known good
one.
3. If the problem still exists, contact
Enterasys Networks for technical
support.
None.
SecureStack C2 Installation Guide 4-3
Using LANVIEW