How to Use This Guide
How to Use This Guide
Read through this guide completely to familiarize yourself with its contents to gain an
understanding of the features and capabilities of the stackable switch. A general
knowledge of data communications networks is helpful when setting up the switch.
This preface provides an overview of this guide and the SecureStack C2 manual set, a
brief summary of each chapter and defines the conventions used throughout this guide.
To locate information concerning various subjects in this guide, refer to the following
table:
For...
An overview of the switch features and how to
obtain technical support
Network requirements that must be met before
installing the switch
Instructions to install the switch on a flat surface
or in a standard 19-inch rack and configure the
switch in a stacked configuration
Troubleshooting installation problems and
diagnosing network/operational problems using
the LANVIEW LEDs
Specifications, environmental requirements, and
physical properties of the switch and optional
Mini-GBICs
Related Documents
The documents listed below provide the necessary information to install and configure
the switch and can be obtained from the World Wide Web in Adobe Acrobat Portable
Document Format (PDF) at the following site:
http://www.enterasys.com/support/manuals
•
SecureStack C2 Installation Guide provides hardware specifications and instructions to
install the switch and its options.
•
SecureStack C2 Configuration Guide describes how to use the Command Line Interface
(CLI) to set up and manage the C2 switch.
•
SecureStack C2 Redundant Power System (C2RPS‐SYS) Installation Guide provides
hardware specifications and instructions to install the power supply and its options.
•
Cabling Guide provides information on dB loss and cable specifications.
Unlike the other documents listed above, the Cabling Guide is not listed alphabetically
on the web site. Instead, it is listed under the Overview Guides link.
xiv About This Guide
Refer to...
Chapter 1,
Introduction
Chapter 2,
Network Requirements
Chapter 3,
Hardware Installation
Chapter 4,
Troubleshooting
Appendix A,
Specifications